Exécution de notre outil de synthèse sur un nouvel article
Vérifiez l’article ci-dessous, puis lancez sa synthèse.
3D Printed porous polyamide macrocapsule combined with alginate microcapsules for safer cell-based therapies
Laura Sáenz del Burgo (University of the Basque Country, Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine), Jesús Ciriza (University of the Basque Country, Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine), Albert Espona‐Noguera (University of the Basque Country, Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine), Xavi Illa (Consejo Superior de Investigaciones Científicas, Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine), Enric Cabruja (Consejo Superior de Investigaciones Científicas, Institut de Microelectrònica de Barcelona), Gorka Orive (University of the Basque Country, Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine), Rosa María Hernández (University of the Basque Country, Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine), Rosa Villa (Consejo Superior de Investigaciones Científicas, Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine), José Luís Pedraz (University of the Basque Country, Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine), Mar Álvarez (Consejo Superior de Investigaciones Científicas, Institut de Microelectrònica de Barcelona)
Résumé : Abstract Cell microencapsulation is an attractive strategy for cell-based therapies that allows the implantation of genetically engineered cells and the continuous delivery of de novo produced therapeutic products. However, the establishment of a way to retrieve the implanted encapsulated cells in case the treatment needs to be halted or when cells need to be renewed is still a big challenge. The combination of micro and macroencapsulation approaches could provide the requirements to achieve a proper immunoisolation, while maintaining the cells localized into the body. We present the development and characterization of a porous implantable macrocapsule device for the loading of microencapsulated cells. The device was fabricated in polyamide by selective laser sintering (SLS), with controlled porosity defined by the design and the sintering conditions. Two types of microencapsulated cells were tested in order to evaluate the suitability of this device; erythropoietin (EPO) producing C2C12 myoblasts and Vascular Endothelial Growth Factor (VEGF) producing BHK fibroblasts. Results showed that, even if the metabolic activity of these cells decreased over time, the levels of therapeutic protein that were produced and, importantly, released to the media were stable.